Technology companies
Teams building electronics that need magnetic components designed for their board, enclosure and power budget rather than taken off a shelf.
Magnetic components and drives
Engineered from the core out
PROTON MAGNETICS LLC develops electromagnets, transformers, inductors, servo drives and magnetic materials for electronics and industrial equipment.
Move your cursor over the field, or tap it, to read its direction.
Five product lines, one discipline
Every line starts with the same question: how much flux, where, and at what loss. Pick a line to see what it covers.
Electromagnets
Wound-core magnets that produce a controlled field only while current flows. Core geometry, winding and duty cycle are developed together so the pull force arrives where the application needs it.
Common applications
- Holding and lifting in industrial equipment
- Actuators, solenoids and locking mechanisms
- Test fixtures and laboratory setups
Transformers
Power and signal transformers that move energy between windings, change voltage levels and provide galvanic isolation. Core material, turns ratio and insulation are chosen for the frequency and load the design will actually see.
Common applications
- Power supplies and converters
- Isolation in control and measurement circuits
- Industrial power distribution equipment
Inductors
Chokes and inductors that store energy in a magnetic field and smooth the current through a circuit. Development focuses on inductance under load, saturation margin and heat.
Common applications
- Filtering in switching power supplies
- Noise suppression on power and signal lines
- Energy storage in DC-DC converters
Servo drives
Drive electronics that control motor position, speed and torque in closed loop. Designed alongside the magnetic components around them, so power stage and motor behave as one system.
Common applications
- Automation and motion control
- Positioning axes in industrial machines
- Embedded drives in equipment built by OEMs
Magnetic materials
Development of the materials that sit inside every other product line: core materials, laminations and magnetic compositions selected for permeability, losses and the operating temperature of the finished part.
Common applications
- Cores for transformers and inductors
- Magnetic circuits for electromagnets and motors
- Material selection for new component designs
From requirement to a part you can build
Development runs in four stages. Each one ends with something you can review before the next begins.
-
Define the magnetic problem
You share the electrical requirements, space envelope, operating environment and the equipment the part goes into.
-
Design the magnetic circuit
Core, material, winding and drive electronics are worked out together, so no single part is optimised at the cost of the others.
-
Prototype and test
Prototypes are built and measured against the requirements agreed in the first stage, then refined where results fall short.
-
Prepare for production
The finished design is documented so it can move into manufacturing and into your equipment.
Who we work with
Industrial manufacturers
Makers of machines and equipment that depend on electromagnets, transformers and servo drives running reliably under real load.
B2B partners
Businesses that integrate magnetic parts or drives into their own products and need a development partner in the United States.
Start a project
Tell us what the component needs to do. The more you share about current, voltage, frequency and space, the faster the first answer.
- Address
- 7512 Dr Phillips Blvd Ste 50-308
Orlando, FL, 32819-5420
United States